Menu

How to remove stickers from glass

Soften the label first: soak a jar in hot soapy water, or warm a window sticker with a hair dryer. Peel it, dissolve the leftover glue with rubbing alcohol or nail varnish remover, then wash the glass.

Researched by Published 20 November 2026Last changed 20 November 2026Verified 17 November 2026Version 1See all changes

Set preferred
Illustration of a softened label being peeled off a glass jar at the sink
On this page 9 sections

Step by step

Hello, and thanks for visiting howtosimply. You probably just wanted the jar without the label. Or perhaps you have recently moved into a new flat and have had a faded parking permit stuck to your window for approximately forever. Either way, removing stickers takes place in two steps: peeling off the outer layer of paper and then removing the underlying adhesive. The key is to soften both layers rather than attempting to scrape them off.

Before you start

  • You'll need: washing-up liquid, a soft sponge or washing-up brush, cotton pads or kitchen roll, rubbing alcohol or nail varnish remover, white vinegar, and for windows a hair dryer and a blunt knife.
  • Time: a jar soak takes at least half an hour (Cleanipedia), and Avery suggests an hour, or overnight for tough labels. The glue step needs about 15 minutes; the vinegar soak runs overnight.
  • This guide is for: glass jars, bottles, drinking glasses, windows and mirrors.
  • Not for: plastic. Heat can warp or melt it, and solvents can mark it.
  • Determine if the glass can get wet. Glass jars, bottles and drinking glasses are usually okay. However, windows, mirrors and framed glass should NOT be submerged in water.
  • Test rubbing alcohol, nail varnish remover or vinegar on a small hidden area first. This is especially important when working around paint, plastic or a wooden frame.
  • Rubber gloves are recommended if you plan on using nail varnish remover or other solvents.
  • Do not use abrasive sponges or scourers, as they can scratch the glass.

Which method for which glass

Jar, bottle or drinking glassWindow, mirror or framed glass
Loosen the labelSoak in hot, soapy waterHair dryer, or a warm wet cloth pressed on
Remove the glueRubbing alcohol, nail varnish remover, or a vinegar soakRubbing alcohol or nail varnish remover on a cloth
Stubborn bitsSoak again, or overnight in diluted vinegarA blunt knife, with care
FinishWash in hot, soapy waterWash with hot, soapy water or window cleaner
  1. Submerge a jar or bottle in hot, soapy water

    Illustration of a glass jar in a sink of hot soapy water with its label fully under the water
    Illustration

    Place the jar in the sink or a large enough bowl filled with hot water and washing-up liquid. Ensure that the part of the jar with the label is below the level of the water. Allow the jar to sit for a minimum of 30 minutes. Tough labels may need an hour, or even overnight.

    Check: the paper looks soggy and a corner lifts with a fingernail. If it doesn't, leave it longer.

  2. Peel off the label

    Illustration of a soaked paper label being peeled off a jar, with a washing-up brush ready beside it
    Illustration

    After the paper becomes soft, carefully pull it off with your fingers. Once most of the paper has come off, scrub away the last bits with a sponge or a washing-up brush.

    Check: no paper is left, only a clear sticky film at most.

  3. Unable to submerge? Try warming the sticker with a hair dryer

    Illustration of a hair dryer aimed at a sticker on a window
    Illustration
    Illustration of a fingernail lifting the warmed edge of a sticker on a window
    Illustration

    For a sticker on a window or mirror, point the hair dryer at the sticker for 30 seconds. Then try to lift a corner of the sticker with your fingernail. If the sticker does not budge, keep heating it in 30-second bursts until it lifts. Save this trick for glass: heat like this can bend plastic out of shape or even melt it.

    Check: the corner lifts and the sticker peels in one piece, or in a few large pieces.

  4. Break down the leftover adhesive

    Illustration of a gloved hand pressing a soaked cotton pad flat on sticky glue on glass, a capped bottle beside it
    Illustration

    Soak a cotton pad or piece of kitchen roll in rubbing alcohol or nail varnish remover. Press the pad flat against the sticky patch and hold it there, or leave it resting on a jar, for about 15 minutes. Then wipe the adhesive off the glass. Rubbing alcohol is gentler than nail varnish remover.

    Check: run a dry finger over the spot. If it still drags, repeat this step or go on to step 5.

  5. Soak stubborn adhesive in diluted vinegar

    Two-panel illustration: a jar fully submerged overnight in diluted vinegar, then rubbed with a microfibre cloth in the morning
    Illustration

    If your jar is still sticky after step 4, submerge it overnight in 1 part white vinegar to 3 parts water. The next morning, gently scrub any remaining adhesive off the jar with a microfibre cloth dipped in neat white vinegar. Vegetable oil works too: dab a small amount directly onto the adhesive and leave it to soak in before wiping it clean.

  6. Use a blunt knife to lift any remaining adhesive

    Illustration of a butter knife held almost flat against window glass, easing leftover glue away
    Illustration

    When cleaning a window, if there is residual adhesive that refuses to budge, use a blunt knife (a butter knife works) to slowly ease it away from the glass. Hold the blade almost flat against the glass and move it gently so you don't scratch the surface.

    Check: look at the glass at an angle against the light. No scratches, and no glue left.

  7. Wash and dry your glass

    Illustration of a clean window being buffed dry with a soft cloth
    Illustration

    Wash your glass with hot, soapy water, or spray window cleaner on the window, and buff it dry with a soft cloth.

How to tell it worked

Once the glass is dry, run a fingertip across where the label was. It should feel as smooth as the rest of the glass, with no drag, no paper fibres and no cloudy patch. If it is tacky, repeat step 4 and wash again. If it is cloudy after vinegar, see below.

Quick checklist

  1. Jar: soak in hot soapy water. Window: warm with a hair dryer
  2. Peel the paper; scrub off the bits
  3. Alcohol or nail varnish remover on a pad, about 15 minutes
  4. Still sticky: overnight in 1 part vinegar to 3 parts water
  5. Window: ease off the last bits with a blunt knife held flat
  6. Wash and buff dry

Soak and wait times by method

ItemWhat it says
Hot soapy water (jar)At least 30 minutes [2]; 1 hour or overnight for tough labels [1]
Hair dryer (glass)30-second bursts until the corner lifts [1]
Rubbing alcohol or nail varnish removerAbout 15 minutes [1]
Jar-in-a-jar hot water10 to 15 minutes, until cool [3]
Diluted vinegar, 1:3Overnight [2]
Graphic by howtosimply, from the sources below[1][2][3].

If something goes wrong

Common mistakes

Illustration of a scourer on glass marked with a red cross, because it scratches the glass
Illustration
  • Scraping at a dry sticker. First, soften the sticker by soaking it in water or warming it with a hair dryer.
  • Using an abrasive sponge or scourer on your glass. Both can scratch glass. Instead, always use a soft sponge or cloth.
  • Applying heat to plastics. Heat can warp or melt plastic. Always check what material your item is made of.
  • Leaving solvent on your glass. Rubbing alcohol is flammable. Make sure to wash your glass thoroughly after using rubbing alcohol or nail varnish remover.
  • There is still a layer of paper stuck to the glass. Soak it again, or press a warm, damp cloth against it and rub softly with a sponge.
  • It still feels tacky after washing. Repeat step 4 with rubbing alcohol or nail varnish remover, then wash again.
  • Your glass looks cloudy after the vinegar soak. Wipe it with equal parts white vinegar and water.

Other ways and adjustments

The jar-in-a-jar soak (iFixit).

Illustration of a small lidded jar standing inside a larger container of hot water, its label loosening under the water
Illustration

Pour boiling water into your labelled jar and screw the lid on. Stand it inside a larger glass container and pour hot water in until it covers the label. Add a few drops of washing-up liquid and cover the large container to keep the heat in. Leave it for 10 to 15 minutes, until the water has cooled. The heat from inside the smaller jar, along with the heat outside, helps break down the adhesive, so a loose label may slip straight off. Please take great care, as this involves boiling water.

  • No rubbing alcohol or nail varnish remover: dab a little vegetable oil on the glue and leave it to soak in before wiping (Cleanipedia).
  • Window you can't wet much: press a warm, damp cloth on the sticker instead of soaking, then use nail varnish remover on a cloth for the glue (Cleanipedia).
  • Painted or wooden frame around the glass: test any solvent on a hidden spot first and keep it off the frame.

Questions

Can I use a hair dryer on a plastic container?

No. Avery says heat can warp or melt plastic.[1]

What if the glass goes cloudy after vinegar?

Cleanipedia says to use equal parts vinegar and water instead of 1 to 3.[2]

I have no rubbing alcohol. What else works?

Dab a little vegetable oil on the glue and let it soak in before wiping.[2]

How do I clean a window I can't soak?

Press a warm wet cloth on the sticker, use nail varnish remover on a cloth for the glue, then wash with hot soapy water or window cleaner.[2]

The pictures on this page are illustrations, not photos.

How we know this: sources, checks and every change

Current advice

Soak or warm the label, peel it, remove the glue with rubbing alcohol or nail varnish remover, then wash. Use a blunt knife on windows, never a scourer.

Advice last changed
20 November 2026 (first version)
Sources
Avery, Cleanipedia and iFixit

Latest update

17 November 2026. We re-opened the sources; the advice on this page matches them.

What changed in this version

  • First version of this article: numbered sources, key facts, what the sources agree on and where they differ, and this record history.

Key facts

  1. Soak jars in hot soapy water for at least 30 minutes (Cleanipedia), or an hour or overnight for tough labels (Avery).[1][2]
  2. On glass, a hair dryer on high for 30 seconds at a time can loosen a paper label. Avery says not to use it on plastic, which can warp or melt.[1]
  3. Rubbing alcohol or nail varnish remover held on the glue for about 15 minutes softens it; alcohol is the gentler of the two.[1]
  4. For stubborn glue, soak overnight in 1 part vinegar to 3 parts water.[2]
  5. Don't scrub glass with the abrasive side of a sponge; on windows, use a blunt knife with care.[2]
  6. Surgical spirit is flammable: don't leave it on the surface.[2]

What the sources agree on

  • Soak water-safe glass in hot soapy water before peeling.[1][2][3]
  • Rubbing alcohol or nail varnish remover lifts the leftover glue.[1][2]
  • Test solvents on a small area first.[1][2]

Where the sources differ, or nothing is confirmed

  • Soak time: Cleanipedia says at least 30 minutes, Avery at least an hour, iFixit 10 to 15 minutes with boiling water inside the jar.[1][2][3]
  • Scraping: Avery suggests a razor blade but does not say it is safe on glass; Cleanipedia uses a blunt knife on windows. We follow Cleanipedia.[1][2]
  • Freezer, peanut butter, WD-40 and baking soda tricks: none of our sources gives them, so they are not on this page.

Record history

  1. Version 1. First published.

No source has changed its advice since we first read it, so there is no "advice that changed" list yet.

Sources

  1. Avery: How to remove sticky labels from plastic, glass and more. Read 14 November 2026 and again on 17 November 2026.
  2. Cleanipedia (Unilever): How to get sticky residue off. Read 14 November 2026 and again on 17 November 2026.
  3. iFixit: How to remove a label from a glass jar. Read 14 November 2026 and again on 17 November 2026.

Sources and method

Researched by
Abu Bakar Saadat
What we checked
No government or university source covers this task, so we used a label maker (Avery), a cleaning brand's guide (Cleanipedia, from Unilever) and a repair site (iFixit), read on 14 November 2026 and opened again on 17 November 2026. Freezer, peanut butter, WD-40 and baking soda tricks are left out because none of these sources gives them. We use a blunt knife on windows, as Cleanipedia does, rather than Avery's razor blade, which Avery doesn't say is safe on glass.
Pictures
11 illustrations drawn for this article, each marked Illustration (drawings, not photos). The table under "Soak and wait times by method" is ours, drawn from the sources.

Did this solve the problem?

Get new guides by email

Our newest guides, sent to your inbox. Free, and you can unsubscribe in one click.

We'll email you to confirm. How we use your email

Follow howtosimply on Facebook

We share every new article on our Facebook page, so the next fix turns up in your feed.

Follow on Facebook

Also on Instagram · Threads · Pinterest · YouTube

What did you think?

Reaction counts are loading.