Menu

How to make two-tone peppermint bark

Researched by 4 min read

Last updated: 21 November 2026References

Set preferred
IllustrationIllustration
On this page 7 sections

In short

Melt dark chocolate, spread it thin on parchment and chill until just tacky, then spread melted white chocolate on top, scatter crushed peppermint sweets and chill until it snaps. No oven, three ingredients, about 20 pieces.

Overview

A thin sheet of dark chocolate topped with white chocolate and crushed peppermint sweets, chilled and snapped into shards. There's no oven and only three ingredients. The one trick is timing: the white layer goes on once the dark layer has firmed up but is still slightly tacky, so the two stick together without swirling.

WhatThis recipe
MakesAbout 20 pieces, 440 g in total
Prep15 minutes
MeltingAbout 5 minutes, in the microwave
Chilling35–55 minutes, in two stages
TotalAbout 55–75 minutes
AllergensContains milk (white chocolate). Chocolate often also contains soya and may contain traces of nuts; check the labels on both bars and the sweets.

Before you start

  • You'll need: a 25 × 35 cm (10 × 14 inch) baking tray that fits flat in your fridge, baking parchment, a resealable food bag, a rolling pin, a chopping board, a knife, a microwave, two dry microwave-safe glass bowls, a silicone spatula and a teaspoon.
  • Keep everything bone dry. Even a drop of water in melting chocolate can make it turn thick and grainy (this is called seizing). Dry the bowls, spatula and spoon well before you start.
  • Buy white chocolate made with cocoa butter, not a cheaper "white coating". Check the ingredients list on the bar.
  • Each picture below shows four moments of its step. Read it from top left to bottom right.

Ingredients

  • 40 g (about 1½ oz) red-and-white hard peppermint sweets or candy canes, unwrapped
  • 200 g (about 7 oz) dark chocolate bar, 50–70% cocoa
  • 200 g (about 7 oz) white chocolate bar made with cocoa butter

Steps

1. Crush the peppermint and make the dark base

Line the tray with parchment. Put the sweets in the food bag, press out the air and seal it. Tap the bag with the rolling pin for about 1 minute, until most of the pieces are about the size of grains of rice, then set it aside. Chop the dark chocolate into pea-sized pieces (smaller than the picture shows, so it melts evenly) and put it in one of the dry bowls.

Microwave at half power in 20-second bursts, stirring well after each one. When only a few small lumps are left, take the bowl out and keep stirring until they melt and the chocolate is smooth. Spread it into a 20 × 24 cm (8 × 9½ inch) rectangle on the parchment. Chill for 5–10 minutes, checking at 5. It's ready when a light touch at the edge leaves a faint mark but no wet chocolate on your finger.

Four illustrated panels: peppermint sweets crushed in a food bag with a rolling pin, chopped dark chocolate in a glass bowl, the melted chocolate stirred smooth with a spatula, and the chocolate spread into a thin rectangle on a parchment-lined tray

2. Add the white layer, chill and snap

Chop the white chocolate into pea-sized pieces and put it in the second dry bowl. Microwave at half power in 15-second bursts, stirring with a clean, dry spatula after each, until the last pieces melt. White chocolate burns more easily than dark, so keep the bursts short.

Spoon small pools of white chocolate over the dark base and gently join them up with the back of the spoon, leaving a thin dark border showing. Straight away, scatter all the crushed peppermint over the soft top. Chill for 30–45 minutes, until the sheet lifts cleanly off the parchment and a corner snaps when you bend it. Break it into about 20 pieces with your hands.

Four illustrated panels: melted white chocolate stirred in a glass bowl, the white chocolate spread over the dark layer with a spoon leaving a dark edge, crushed peppermint scattered over the top, and the set bark snapped into shards showing dark and white layers

If this doesn't work

  • The layers start to swirl together: stop spreading, chill the tray for 2 minutes, then cover the streak with a little more white chocolate from the bowl. Use short, light strokes with the back of the spoon.
  • The chocolate went thick and grainy while melting: it has either got too hot or touched water. It can't be fixed for this recipe. Start again with fresh chocolate and a fully dry bowl, and use shorter bursts.
  • The layers separate when you snap the bark: the dark layer was too firm before the white went on. Next time, check it at 5 minutes and add the white layer while the dark is still a little tacky.

Serving and storing

Serve on a small plate with coffee, or put the pieces into paper cases to give as presents. Keep them in an airtight tin with parchment between the layers, somewhere cool and dry. If your kitchen is warm, keep the tin in the fridge and let it sit, still closed, for 15 minutes before opening so moisture doesn't form on the peppermint and make it sticky.

The pictures in this recipe are illustrations.

Sources and method

Researched by
Abu Bakar Saadat
Pictures
2 illustrations drawn for this article: drawings, not photos.

Did this solve the problem?

Get new guides by email

Our newest guides, sent to your inbox. Free, and you can unsubscribe in one click.

We'll email you to confirm. How we use your email

Follow howtosimply on Facebook

We share every new article on our Facebook page, so the next fix turns up in your feed.

Follow on Facebook

Also on Instagram · Threads · Pinterest · YouTube

What did you think?

Reaction counts are loading.